This is the heater for the cold garage, the unfinished build or the barn, not for the living room. A fan drives air across an open propane flame and pushes a column of hot air down the barrel, which warms a large draughty space far faster than a radiant heater can. Because it runs off a DEWALT 20V MAX or 20V/60V FLEXVOLT battery rather than a wall socket, it still works when there is no power on site at all, which is what earns it a place in a preparedness kit.
Key features
- Runs on the DEWALT 20V MAX battery system, FLEXVOLT compatible, so no mains supply is needed
- Thermoelectric safety valve shuts off the gas if the flame goes out
- High-temperature limit switch cuts the heater if it overheats
- Quiet burner technology, and a split barrel that opens for maintenance
- Hose and regulator supplied, for connection to a refillable propane tank
- CSA certified, with a one-year limited warranty
Specifications
- Output: the rating label on the barrel reads 68,000 BTU, with an adjustable output control
- Fuel: propane, from a refillable tank via the supplied hose and regulator
- Power: DEWALT 20V MAX or FLEXVOLT battery; DEWALT lists a handle, hose and regulator in the box, and no battery among the contents
- Oxygen-depletion sensor: none fitted
- Tip-over shut-off: none listed
- Rated area: DEWALT publishes no floor-area rating for this model
Two honest notes. First, DEWALT’s own product page is headed 70,000 BTU while the label on the heater reads 68,000 BTU; the figure on the unit is the one to work from. Second, and far more important: this is a direct-fired, unvented heater with no oxygen-depletion sensor. Every product of combustion, carbon monoxide included, goes straight into the space you are standing in. The maker intends it for temporary heating of buildings under construction, alteration or repair. Run it only where there is a generous and permanent supply of outside air, keep a working carbon monoxide alarm in the space, and never use it in a tent, a vehicle, a closed basement or any room where someone will sleep. DEWALT does not publish a run time, which depends on the tank you connect.




