Skip to content

Miller LPR-100 Half Mask Respirator with P100 Filters (Small/Medium, ML00894)

Miller LPR-100 low-profile half mask supplied with two P100 filters, size small/medium. NIOSH 42 CFR Part 84, APF 10, and particulate protection only.

Ships from our US fulfilment network. Delivery & returns →

As an Amazon Associate, PrepperSource earns from qualifying purchases.

Category:

Miller Electric built the LPR-100 for welders, and the design shows it. The mask sits unusually flat against the face so it clears a helmet shell and does not push protective eyewear out of position, and a wrap-around spark guard shields the filter media from sparks and grinding debris. Outside the welding bay it suits anyone working in dust, metal fume or mist: grinding, demolition, insulation work, or clearing up after a fire. It comes ready to use with two P100 filters.

Key features

  • Very low-profile moulding clears most welding helmets and leaves protective eyewear sitting where it should
  • P100 filters remove up to 99.97 per cent of airborne particulate, including solid dust, metal fume and mists, and are strongly resistant to oil
  • Wrap-around spark guard protects the filter media from sparks and flying debris
  • Large non-return exhaust valve vents heat and moisture, which cuts lens fogging and wearer fatigue
  • Turnbuckle filter mounts make a filter change quick, and four-point strap adjustment with an integrated cushion sets the fit
  • Built from medical-grade materials: free of latex and silicone, odour free and non-allergenic

Specifications

  • Model LPR-100, part ML00894, size small/medium; the medium/large is ML00895
  • Supplied with two P100 particulate filters
  • NIOSH certification 42 CFR Part 84; filter classification P100
  • OSHA classification tight-fitting respirator, with an assigned protection factor of 10
  • Pleated filter design, which adds surface area to lower breathing resistance while keeping the filter small
  • P100 filters with nuisance-level organic vapour relief are available separately for odour, not for vapour protection

Three things to know before you buy. This is a particulate respirator: the P100 filters stop solids and mists and will not remove solvent vapour, chlorine, carbon monoxide or any other gas, and no filter mask works in an atmosphere short of oxygen. Miller’s nuisance-level organic vapour filters only take the edge off odours at concentrations below occupational exposure limits, so they are not vapour protection either. Second, this is the original LPR-100; Miller’s current catalogue model is the LPR-100 Gen II, so buy this as the earlier generation rather than the latest one. Third, like any tight-fitting respirator it needs a fit test, a seal check every time it goes on, and a clean-shaven sealing area, because stubble leaks.