The Archer 2A V3 is a 155 mm penlight built around two AA cells, which is the reason to choose it: no charging circuit to fail and no proprietary pack to source, just the commonest battery size there is. A tail switch handles on, off and momentary light while a side switch steps through the output levels, so it can be worked one-handed whether held overhand or in the fingers.
Key features
- Powered by two AA cells, alkaline or rechargeable NiMH, so stored batteries keep it in service
- Dual controls: tail switch for on, off and momentary; side switch for output selection
- Five outputs including a 0.2-lumen firefly level and a strobe
- Removable stainless steel pocket clip that also holds to a cap brim or a clipboard
- Hard-anodised aluminium body, rated to IPX8 and to a one-metre drop
- Supplied with lanyard, clip, spare O-rings and manual
Specifications
- Emitter: CREE XP-L2; outputs 500, 70, 17 and 0.2 lumens, plus 400-lumen strobe
- Run times: high 3.33 minutes then about 120 minutes at the stepped level; mid 11 hours; low 51 hours; firefly about 15 days
- Beam distance: 93 metres (305 ft)
- Battery: 2 x AA, not included
- Dimensions: 155 mm long, 22 mm diameter; weight 48 g without cells
- Water and impact: IPX8, submersible to 2 metres; one-metre drop resistance
Two caveats worth knowing before you buy. The 500-lumen figure holds for about three and a half minutes and then settles to roughly 280 lumens, which is normal for a light this size and still plenty for walking or working; and the cells are not included, so order a set with it. If it is going into a vehicle or a go-bag for the long term, check the alkaline cells once or twice a year, or fit lithium AAs, which tolerate storage and cold far better.




