Skip to content

Battery power stations: read the watt-hour, output and input ratings separately

A portable battery power station with a carry handle and covered outlets.
AI-generated editorial illustration

Choose a battery power station by writing down the devices you want to power and checking their running demand and any stated start-up surge. Then compare the station’s nominal energy, output limits and charging input for the exact model. Goal Zero’s US 120 V manual gives separate figures for those fields. The maker also says AC conversion loses energy, so the full rated battery capacity may not be delivered to a connected device. Goal Zero Yeti 300, 500 and 700 US manual

Compare the exact US 120 V ratings

Model and US SKU Nominal pack capacity Listed AC output and surge Maximum AC input
Yeti 300, 36900 296.96 Wh 350 W, 600 W surge 420 W
Yeti 500, 37000 499.2 Wh 500 W, 1,000 W surge 500 W
Yeti 700, 37100 677.376 Wh 600 W, 1,000 W surge 500 W

The AC output row is for the station. Check the manual’s exact port and combined-output limits for the items you plan to connect. The maximum input describes charging into the station. It does not establish a charging time for your setup. Goal Zero US 120 V ratings table

Record the load before estimating energy demand

Check What to write down
Device Exact device, port and maker-rated running demand
Start-up Any separate surge figure and which devices might start together
Intended use Hours you plan to run each device and whether it cycles
Charging Approved input and exact charger or panel specifications
Conditions Where the station will sit and the conditions its instructions allow

Hypothetical example. A device drawing a constant 30 W for four hours would require 120 Wh at the load. That arithmetic describes the device’s demand under the stated assumption. A station’s usable energy depends on the actual load and conditions, including conversion losses. Goal Zero also notes that below-freezing conditions can affect capacity. Goal Zero best-use and cold-weather guidance

Check the manual’s use limits

Goal Zero directs users to operate these units in a dry, well-ventilated place with unobstructed fan openings. For solar charging it warns against exceeding 30 V, including panels in series. The same manual says these units are not certified as an uninterruptible power supply and prohibits use with life-saving medical equipment. Use the instructions for your exact model and confirm compatibility before connecting a device. Goal Zero US 120 V safety and input instructions

Verify one device and one port

Read the intended device’s rating and find the corresponding output row in the station’s manual. Keep any unknown start-up, usable energy or charging requirement on the worksheet until you can verify it.

Explore portable power and solar guides